Illustrative exampleAutomotive
Mounting bracket with folded ribs
A folded bracket that holds a sensor module, produced with paired ribs to keep the part rigid at speed.
- Material
- Galvanized steel
- Process
- Progressive die stamping
04 / Case Studies
Part types we are asked to make.
Each example shows the part family, the process route and the checks that matter. Client names, drawings and part numbers stay confidential.
Note
The examples below are illustrative of part families we work with, not published client projects. Production references are shared during supplier discussions.
Illustrative example
Illustrative exampleElectronics
Contact terminals from copper strip
Small contact terminals stamped from copper strip, kept flat and burr-free for automated insertion.
- Material
- Copper alloy
- Process
- Progressive die stamping
Illustrative exampleAppliances
Control panel housing shell
A drawn housing for a control board, with a shallow flange and punched openings for connectors.
- Material
- Cold rolled steel
- Process
- Deep drawing
Illustrative exampleBuilding Hardware
Window hardware fitting
A visible stainless fitting assembled from two stamped halves and a riveted pivot.
- Material
- Stainless steel
- Process
- Stamping and assembly
Illustrative exampleIndustrial
Cable clamp with spring tab
A clamp stamped from spring steel with a formed tab that holds cable routing without fasteners.
- Material
- Spring steel
- Process
- Progressive die stamping
Illustrative exampleElectronics
Instrument shielding cover
A formed aluminium cover for a measuring instrument, with ventilation slots and a brushed finish.
- Material
- Aluminium sheet
- Process
- Stamping and finishing
Your part is not on this list?
These are part families, not limits. Send the drawing of the component you need and we will confirm whether the geometry suits stamping or another process.